Copy Settings From Another Location; Set Location Alarms - Beckman Coulter MET ONE 3400 Instructions For Use Manual

Configuration
Locations, Areas and Groups
5
Select the
• Set the count cycles and the count mode.
• Select the run mode.
• Set the count display option.
6
Select the
• Set the duration for each sample.
• Set the sample hold time between count cycles.
• Set the sample delay time to allow delay before the sample test begins.
7
Push
RETURN

Copy Settings from Another Location

1
On the Counter Navigation screen, push
2
On the Area/Location Setup screen, select the area that includes the destination location.
3
Select the location where the copied settings should go. Push
4
Push
YES

Set Location Alarms

The particle counter allows different alarm settings for individual locations.
NOTE
Use this feature when the Use Location Settings is selected in Group Settings.
1
On the Counter Navigation screen, push
2
On the Area/Location Setup screen, select an area.
3
Select a location within the area. Push
6-14
tab.
General
tab.
Timing
to go back to the Add Sample Location screen.
to confirm or push to cancel.
NO
.
LOCATIONS
.
LOCATIONS
or
ADD LOCATION EDIT LOCATION
.
as needed.
DOC026.53.80202, Edition 7