Table of Contents
Advertisement
Configuration
Locations, Areas and Groups
2
Select the
3
Insert the USB drive with the configuration data into the USB host connector. Refer to
Figure
3.3.
4
Push
READ CONFIGURATION FROM USB
5
A confirmation message will show.
6
Remove the USB drive.
7
Push
OK
Locations, Areas and Groups
A location defines a space, such as a work bench, that is identified for sample testing. To add,
change or remove a location, refer to
An area is a group of defined locations that are geographically co-located. For example, Cleanroom
A is an area. The work benches inside Cleanroom A may be defined as locations. To add, change or
remove an area, refer to
Groups are locations that have common sampling attributes. For example, all locations that are
tested every month may form one group. Locations in a group do not have to be co-located. To add,
change or remove a group, refer to
Location Management
Add a Location
1
On the Counter Navigation screen, push
2
On the Area/Location Setup screen, select an existing area, or if needed, create a new area and
then select it. Push
6-12
tab.
Configuration
to restart the instrument and load the new configuration.
Location
Area
Management.
Group
ADD LOCATION
.
Management.
Management.
.
LOCATIONS
.
DOC026.53.80202, Edition 7
Advertisement
Table of Contents
