Operation; Log On To The Particle Counter; Measure Particle Counts - Beckman Coulter MET ONE 3400 Instructions For Use Manual

Log on to the Particle Counter

Prerequisites
• Start the system.
• Enable password protection. Refer to
1
Activate the backlight with a finger or stylus if needed.
2
Push the
3
Enter the user name and password. Confirm.
NOTE
Push the ALT key to access special characters.

Measure Particle Counts

After a complete particle count measurement, the number of particles measured will show
on the screen and be stored as data. Other configured parameters, such as relative humidity,
temperature and air velocity will be shown and stored in data.
1
Remove the protective cap from the inlet tube on the counter.
2
On the Counter Navigation screen, push
3
To start the particle count, push
measured.
NOTE
Push
stored or printed unless the Save Partial Data option is selected in System Settings. Refer to
Partial
DOC026.53.80202, Edition 7
icon to log out a previous user. Push
. The
to end the test before the count is complete. Incomplete particle count data will not be
Data.
Enable the User Logon Function.
again to see the logon screen.
.
SAMPLE
icon will change to a
CHAPTER 7

Operation

button while the count is
Store
7-1