Assemble the Particle Counter System
Figure 3.4
shows the setup of the particle counter system.
Figure 3.4 Particle Counter Assembly
1. Remote installation of the probe
a. Shown with the optional isokinetic probe stand. Refer to
Install the Printer Paper
IMPORTANT
recommended thermal paper. If the particle counter must be used without paper, be sure to set the print
mode to "None".
Refer to the illustrated steps in
DOC026.53.80202, Edition 7
a
To avoid damage to the printer, do not operate the printer without paper. Use only the
Figure 3.5
Assemble the Particle Counter System
2. Local installation of the probe
3400 Series Parts
for ordering information.
to install printer paper.
3
Installation
3-5