Table of Contents
Advertisement
4
Select the Date field. Use the numeric keypad to enter the current date in the YYYY-MM-DD
format, then confirm.
Set the Sleep Mode and Backlight Timeout
Sleep mode and backlight time are active during battery use. When the instrument is connected to
AC power, sleep mode and backlight are not active.
During sleep mode the instrument goes into hibernation after a period of inactivity to conserve
power. All subsystems are shut down. The time value for sleep mode is in minutes.
The backlight setting turns off the LCD backlight after a period of inactivity to conserve power. The
time value for the backlight setting is in seconds.
1
On the Counter Navigation screen, push
2
Select the
3
Select the Sleep Time field. Enter the length of idle time before sleep mode begins, then
confirm. The range is 1 to 30 minutes.
NOTE
Enter 0 to disable sleep mode.
4
On the
Basic
interface backlight turns off, then confirm. The range is 5 to 300 seconds.
NOTE
Enter a value of less than 5 seconds to disable backlight timeout.
To bring the instrument out of backlight timeout, use a finger or a stylus to make the user
interface touchscreen active.
Set the Alarm Reasons Option
To capture data about why alarms occur, the Alarm Reason option is set as Required or Optional. In
both Required and Optional mode, the user is prompted to select from preset alarm reasons for the
alarm event. All users can enter alarm reasons. Only administrators, factory-level users or users
with System Settings permissions can disable or change the Alarm Reasons option.
To enable or disable Alarm reasons:
1
On the Counter Navigation screen, push
DOC026.53.80202, Edition 7
tab.
Basic
tab, select the Backlight Timeout field. Enter the length of idle time before the user
.
SYSTEM
.
SYSTEM
6
Configuration
Configure the System
6-3
Advertisement
Table of Contents
