Table of Contents
Advertisement
3
Select the yellow text below Counts to show the Alarm Reasons list.
NOTE
The yellow text shows the type of alarm that has been recorded.
4
Select an alarm reason from the list. Push
Set the Inert Gas and Altitude Values
After factory calibration, an inert gas can be selected. The particle counter applies a correction
factor to the flow rate based on the inert gas selection.
1
On the Counter Navigation screen, push
2
Select the
3
Select the Gas field, then select the gas to be tested.
NOTE
Only the gases that the instrument has been calibrated with will show in the list.
4
Select the Altitude field.
5
Select the altitude of the measurement location. The altitude values are shown in feet.
Set the Particle Count Alert (Beep Function)
The instrument can be set to play a sound when an interval value is counted on a specified channel.
For example, when the interval value is 100, the counter will beep each time it counts 100 particles.
1
On the Counter Navigation screen, push
2
Select the
3
Select Quick Settings.
4
Push
YES
DOC026.53.80202, Edition 7
tab.
Custom
tab on the right side of the screen.
Settings
to edit settings for the default group.
.
ENTER
.
SYSTEM
.
SAMPLE
6
Configuration
Configure the System
6-9
Advertisement
Table of Contents
