Using The Timer Function; Spo 2 Measurement (Optional); To Delete The Logbook; Selecting A Sensor - Dräger Primus Infinity Empowered Instructions For Use Manual

Monitoring

To delete the logbook

Logbook and trend memory are deleted simultane-
ously!

Using the timer function

O
2
AIR
N O
2
To start the timer (e.g. "00:00"):
Press the soft key start timer in any operating
mode.
O
2
AIR
N O
2
SpO measurement (optional)
2
The SpO module displays the SpO
2
as the corresponding upper and lower alarm limits
and the pulse rate.
99
99
SpO
2
92
67
160
config.
start timer
config.
stop
00:17
-value as well
2
The logbook will be maintained even after switching
off the Primus Infinity Empowered completely. It
can only be deleted by using the delete trend func-
tionality in Standby, see page 158.
To stop the timer:
Press the soft key
The measured time is displayed.
O
2
AIR
N O
2
To reset the timer to "00:00":
Press the soft key reset.

Selecting a sensor

Only OxiMax sensors or Durasensors from Nellcor
must be used (see separate list of accessories).
The OxiMax modules implemented in Primus
Infinity Empowered are only compatible with the
OxiMax sensors (purple probe or white probe for
MAX FAST).
Instructions for use Primus Infinity Empowered SW 4.5n
stop.
config.
delete
00:17