Table of Contents
Advertisement
3.
Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
4.
Remove the access panel.
5.
Remove the air baffle.
The air baffle is no longer needed. The drive cage acts as an air baffle for the server.
6.
Remove all riser cages.
7.
Connect the power cable to the drive backplane power connector on the system board.
8.
If connecting the data cable to the system board or a controller, connect the data cable.
9.
Prepare the drive cage for installation by lifting the latches on the drive cage.
10. Install the drive cage:
Hardware options installation
103
Advertisement
Table of Contents
