Table of Contents
Advertisement
Prerequisites
Before installing this option, be sure you have the following:
The components included with the hardware option kit
For more information on specific options, see the server QuickSpecs on the Hewlett Packard Enterprise
website.
Procedure
1.
Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Do one of the following:
a. Extend the server from the rack.
b. Remove the server from the rack.
4.
Remove the access panel.
5.
Open the DIMM slot latches.
6.
Install the DIMM.
7.
Install the access panel.
8.
Install the server in the rack.
9.
Connect each power cord to the server.
10. Connect each power cord to the power source.
11. Power up the server.
Use the BIOS/Platform Configuration (RBSU) in the UEFI System Utilities to configure the memory mode.
80
Hardware options installation
Advertisement
Table of Contents
