Table of Contents
Advertisement
d. Save the configuration and reboot the server.
e. Create an array:
I.
II.
Deploy an OS or virtualization software
8. Do one of the following:
•
Run Intelligent Provisioning to deploy an OS.
Press F10 at the boot screen to run Intelligent Provisioning.
IMPORTANT: Smart array MR controllers are not supported by Intelligent Provisioning or Smart
Storage Administrator.
•
Manually deploy an OS.
a. Insert the installation media.
For remote management, click Virtual Drives in the iLO remote console to mount images, drivers,
or files to a virtual folder. If a storage driver is required to install the OS, use the virtual folder to store
the driver.
b. Press F11 at the boot screen to select the boot device.
c. After the OS is installed, update the drivers.
9. Register the server (http://www.hpe.com/info/register).
Operational requirements
Space and airflow requirements
To allow for servicing and adequate airflow, observe the following space and airflow requirements when
deciding where to install a rack:
•
Leave a minimum clearance of 63.5 cm (25 in) in front of the rack.
•
Leave a minimum clearance of 76.2 cm (30 in) behind the rack.
•
Leave a minimum clearance of 121.9 cm (48 in) from the back of the rack to the back of another rack or
row of racks.
Hewlett Packard Enterprise servers draw in cool air through the front door and expel warm air through the
rear door. Therefore, the front and rear rack doors must be adequately ventilated to allow ambient room air to
enter the cabinet, and the rear door must be adequately ventilated to allow the warm air to escape from the
cabinet.
CAUTION: To prevent improper cooling and damage to the equipment, do not block the ventilation
openings.
58
Setup
From the boot screen, press F9 to run UEFI System Utilities.
From the UEFI System Utilities screen, select System Configuration > Embedded
Storage: HPE Smart Storage S100i SR Gen10 > Array Configuration > Create Array
Advertisement
Table of Contents
