Table of Contents
Advertisement
CAUTION: Do not drop the drive cage on the system board. Dropping the drive cage on the system
board might damage the system or components. Remove all drives and use two hands when
installing or removing the drive cage.
a. Locate the alignment pins on the rear of the drive cage.
b. Align the pin on the rear left of the drive cage to the server and then insert the pin.
c. Gently lower the opposite side of the drive cage.
d. Pull the plunger pin on the rear right of the drive cage and then lower the drive cage until the plunger
pin engages.
11. Install drives or drive blanks.
12. Push down on the latches to lower the drive cage into place.
13. Connect the power and data cables to the drive backplane.
104
Hardware options installation
Advertisement
Table of Contents
