* Displayed after autotuning has been completed. For parameters in which no error is detected, the settings are reset to the values determined by autotuning.

Errors when Using the Digital Operator Copy Function

The errors that can occur when using the copy function from the Digital Operator are given in the following

table. An error code will be displayed on the Digital Operator. If a Digital Operator key is pressed when an

error code is being displayed, the display will be cleared and 03-01 will be displayed. The error contact output

and alarm output will not function.

Func-

Display

tion

Digital Operator

READ

write-protected

IMPOSSIBLE

Illegal read data

Read

READ DATA

ERROR

Illegal write status

DATA ERROR

Table 7.4 Errors During Autotuning (Continued)

Probable causes

Autotuning was not completed in the

specified time.

PG pulses were input when the Inverter

was outputting a frequency.

The torque reference exceeded 100%

and the no-load torque exceeded 70%

during autotuning.

The results of autotuning has exceeded

the setting range for a user parameter so

a temporary setting was made for the

motor core saturation coefficient.

The rated current is set high.

As a result of stationary autotuning 1,

the slip value has fallen to 0.2 Hz or

below.

Table 7.5 Errors during Copy Function

Meaning

Probable causes

o3-01 was set to 1 to write a parameter

when the Digital Operator was write-

protected (o3-02 = 0).

The read data length does not agree.

The write data is incorrect.

An attempted write of a parameter to

EEPROM on the Digital Writer failed.

Protective and Diagnostic Functions

Corrective Actions

Check the motor wiring.

Fix the broken/disconnected wiring.

• Check and correct the settings.

• Disconnect the load from the motor.

• Check the input data.

• Check motor wiring.

• If the motor is connected to the

machine, disconnect it.

Check the input data (particularly the

motor output current and motor rated

current).

• Check the input data.

• If rotational autotuning is possible,

perform it. If impossible, perform sta-

tionary autotuning 2.

Corrective Actions

Set o3-02 to 1 to enable writing

parameters with the Digital Operator.

Repeat the read.

Check the Digital Operator cable.

Replace the Digital Operator.

A low Inverter voltage has been

detected.

Repeat the read.

Replace the Digital Operator.

Table of Contents

Troubleshooting

This manual is also suitable for:

3g3rv-v1

Errors When Using The Digital Operator Copy Function - Omron SYSDRIVE RV Series User Manual