Digital Operator Keys - Omron SYSDRIVE RV Series User Manual

Digital Operator Keys

The names and functions of the Digital Operator Keys are described in Table 3.1.
Key
L OC A L
LOCAL/REMOTE Key
REMOTE
MENU Key
MENU
ESC Key
ESC
JOG Key
JOG
FWD
FWD/REV Key
REV
Digit Selection/RESET Key
RESET
Increment Key
Decrement Key
ENTER Key
RUN Key
RUN
STOP Key
STOP
Note Except in diagrams, Keys are referred to using the Key names listed in the above table.
Table 3.1 Key Functions
Name
Switches between operation via the Digital Operator (LOCAL) and
control circuit terminal operation (REMOTE).
This Key can be enabled or disabled by setting parameter o2-01.
Selects menu items (modes).
Returns to the status before the ENTER Key was pressed.
Enables jog operation when the Inverter is being operated from the
Digital Operator.
Selects the rotation direction of the motor when the Inverter is being
operated from the Digital Operator.
Sets the number of digits for parameter settings.
Also acts as the Reset Key when a fault has occurred.
Selects menu items, sets parameter numbers, and increments set val-
ues.
Used to move to the next item or data.
Selects menu items, sets parameter numbers, and decrements set val-
ues.
Used to move to the previous item or data.
Pressed to enter menu items, parameters, and set values.
Also used to switch from one screen to another.
Starts the Inverter operation when the Inverter is being controlled by
the Digital Operator.
Stops Inverter operation.
This Key can be enabled or disabled when operating from the control
circuit terminal by setting parameter o2-02.
Digital Operator
Function
3
3-