Tecomec GEOline GEOSYsTEM 240 Instruction Manual page 85

Use
10
Press the
configuration.
Go to the next step to verify the operation of the valves otherwise skip to step number
11 Set the number 4 and press the
key to confirm.
The new message "General config.
12
Number of valves" is then displayed.
13
Press the
relaunch the monitor.
14 When the monitor is in operating mode, activate switch number 1 (ON position) and
check that valve number 1 is working.
Then, disable switch 1 (OFF position) and try with switch number 2. Repeat the test
for all valves.
Figure 30 - Use of 4 sections
84
-
key to enter the
key to exit and to
15.
GeoSystem RevA6