Table of Contents
Advertisement
Use
14 HARDWARE TEST
This allows a hardware test of the monitor to be carried out to check that the switches
and sensor inputs are working.
This test can be carried out only at start-up.
1
Turn on the monitor by pressing
2
After viewing the Firmware version,
when the "Please Wait" message
appears, press the
keys at the same time.
The "Test HW" message will appear.
3
4
The Voltage value will then be shown
and it is possible to scroll through the
values using
5
The next value is the analog input 1
value for the Switch Box board
corresponding to the pressure sensor.
The next value is the analog input 2
6
value for the Switch Box board
corresponding to the tank level sensor.
7
The next value is the external counter
1 value corresponding to the flowmeter
input
.
and
and
keys.
GeoSystem RevA6
57
-
Advertisement
Table of Contents
