Tecomec GEOline GEOSYsTEM 240 Instruction Manual page 77

Use
Go to the next step to verify the operation of the valves, otherwise skip to step number
11 Set the number 5 and press the
key to confirm.
The new message " General
12
configuration Number of valves" is
then displayed.
13
Press the
restart the monitor.
14 When the monitor is in operating mode, activate switch number 1 (ON position) and
check that valve number 1 is working.
Then, disable switch 1 (OFF position) and try with switch number 2. Repeat the test
for all valves.
76
-
key to exit and to
15.
GeoSystem RevA6