Table of Contents
Advertisement
Configuration
-
Both: the system uses the
flowmeter or pressure sensor to
adjust the dose (l/ha). When the
flow rate (l/min) falls below the
value set in point 5: Minimum
flow rate alarm threshold.
23
Liquid tank specific weight:
Only if the sensor level = YES, this
allows the tank level to be calculated as
a function of the specific weight of the
liquid inside.
24
Tank level sensor:
By choosing YES, the measured level
is used in the tank refilling procedure. If
NO is chosen, the default value is
used.
Press the
value.
Percentage display value tolerance:
25
This determines the sensitivity of the
display.
0 - 20 %
26
Section management:
• D: this is dependent mode,
where if the main valve is
closed, the open section valves
are also closed; the LEDs are
turned off with the switches in
any position. If the main valve is
reactivated, then the other
valves are also reactivated with
the switches in the ON position
• I: this is independent mode,
where the section valves stay
open even if the main valve is
closed.
27
Regulating valve type:
Bypass / Throttling
38
-
key to enter a new
GeoSystem RevA6
Advertisement
Table of Contents
