Table of Contents
Advertisement
Use
15.6 TURNING OFF the GeoSystem
1
Press the
order to turn off the system.
2
Wait for the data of the last treatment to
be saved.
During the turning off procedure, do not press any key and do not cut off the power, until
the monitor turns off.
Always use the appropriate key to turn off the system, otherwise all the data relating to
treatments and programs will be lost.
15.7
PREPARATION
1
Make sure all the switches are in the
OFF position.
2
Turn on the monitor by pressing the
key.
3
Set the amount of liquid that is in the
tank in GeoSystem.
4
To start the data recording for a new
treatment, select any operating cycle
parameter, except the "tank level"
parameter.
5
The system stores the treatment data
in a list of 20 elements.
6
Press the
save the most recent data stored in the
list and reset all the counters,
preparing to record the data relating to
the new treatment to be performed.
N.B. if there is no level sensor, by
pressing the key, all the operating data
will be reset, except the tank level,
key for 2 seconds in
key for 5 seconds to
GeoSystem RevA6
65
-
Advertisement
Table of Contents
