Tecomec GEOline GEOSYsTEM 240 Instruction Manual page 59

Use
The next value is the external counter
8
2 value corresponding to the speed
sensor input.
9 The next value indicates the status of
the switches.
0 = OFF
1 = ON
By turning on the switches, the status
will change from 0 to 1 and turning
them off will return the value to 0.
10 This step allows the correct
functioning of the keys to be checked.
The "Press a key" message will be
displayed.
11 By keeping the specific key pressed
down, the name of the key appears
temporarily on the display.
By pressing the Reset key, first the
"RESET KEY" message appears,
then the monitor moves on to the
buzzer test.
12 Buzzer test.
During this step, an acoustic signal
will be activated, confirming the
correct functioning of the buzzer.
13 GPS Check
Press the OK key to run the test to
check the correct functioning of the
GPS.
14 The following message will be shown
on the display:
15 During the test, the monitor will show
the following data received from the
GPS:
58
-
GeoSystem RevA6