Table of Contents
Advertisement
Configuration
3
Current flow rate in liters/minute (or
gallons/minute)
The "@" symbol before the value
indicates that the flow rate value has
been calculated and not measured by
the specific sensor. This happens if and
only if the "Section valve type"
parameter is set as "Metered".
4
Extension of the treated area since
the beginning of treatment
5
Total liquid sprayed since the
beginning of treatment
6
Current tank level:
This parameter allows the following 2
operations to be performed.
Press the
tank value using the
keys.
Press the
the value.
When increasing the value, keep the
key pressed without releasing
it, and the value will increase, and then
after 30 units it will pass to tens to
accelerate the operation.
44
-
key to modify the
and
key again to confirm
GeoSystem RevA6
Advertisement
Table of Contents
