Table of Contents
Advertisement
Use
Switch on the Geosystem by pressing
When the "Please Wait" message appears, press the
and
keys at the same time.
The Geosystem is now in hardware test mode.
The Voltage value will appear and it is possible to scroll
through the values using the
Select the "Check GPS" menu
Press the
key to run a test to check the correct
functioning of the GPS
During the test, Geosystem will show the data received from the GPS:
▪ Latitude (LAT)
▪ Longitude (LON)
▪ Degree of accuracy of the GPS tracking (HDOP)
▪ Type of calculation used to detect position (FIX)
At the beginning, the fix value may be 0 (no detected
position).
After a few minutes, the fix value will be:
1 (position detected by GPS)
2 (position detected by DGPS):
After 30 minutes, if the "Fix" value is still 0, go to the troubleshooting menu
72
-
.
and
keys.
GeoSystem RevA6
Advertisement
Table of Contents
