Deutz Emr2; John Deere; Mtu Mdec - Smartgen HGM8140D User Manual

13.9 DEUTZ EMR2

F connector
Relay Output 1
Start relay output
-
CAN_SCR
CAN(H)
CAN(L)
Engine Type：Volvo EDC4.

13.10 JOHN DEERE

Terminals of controller
Relay Output 1
Start relay output
CAN_SCR
CAN(H)
CAN(L)
Engine type: John Deere

13.11 MTU MDEC

Suitable for MTU engines, 2000 series, 4000series
Terminals of controller
Relay Output 1
Start relay output
CAN_SCR
CAN(H)
CAN(L)
Engine type: MTU-MDEC-303
HGM8140 Military Genset Controller
HGM8140 MILITARY GENSET CONTROLLER USER MANUAL
Table 29 F Connector
Remark
Expand 30A relay, battery
voltage of 14 is supplied by
relay. Fuse is 16A.
-
1
-
12
13
Table 30 21 Pins Connector
21 pins connector
G，J
D
-
V
U
Table 31 X1 Connector
X1 connector
BE1
BE9
E
G
F
Configure relay output 1 as "Fuel Output"
Connect to starter coil directly.
Connect to battery negative pole.
CAN communication shielding line (connect with
controller‟s terminal only).
Impedance 120Ω
recommended.
Impedance 120Ω
recommended.
Configure relay output 1 as "Fuel Output"
CAN communication shielding line (connect with
controller‟s terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Configure relay output 1 as "Fuel Output"
CAN communication shielding line (connect with
one terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Version 1.2 2019-09-12
F connector
connecting line
connecting line
Remark
Remark
Page 50 of 56
is
is