Table of Contents
Advertisement
No.
Items
Shutdown
Gen
Under
18
Shutdown
Under
19
Shutdown
Over
20
Shutdown
Under
21
Shutdown
Over
22
Shutdown
High
23
Shutdown
Low Oil Pressure
24
Shutdown
25
Low Fuel Level
26
Loss
of
HGM8140 Military Genset Controller
HGM8140 MILITARY GENSET CONTROLLER USER MANUAL
Parameters
Volt
(30-620)V
Speed
(0-6000)RPM
Speed
(0-6000) RPM 1710
Freq
(0-75.0)Hz
Freq
(0-75.0)Hz
Temp.
(0-300)º C
(0-1000)kPa
(0-100)%
Speed (0-20.0)s
Defaults
set value and the "Gen abnormal delay" has
expired, Gen Over Voltage Shutdown alarm
is active. When set the value as 620V, the
controller does not detect over voltage
signal.
When generator voltage has fallen below
the set value and the "Gen abnormal delay"
has expired, Gen Under Voltage Shutdown
196
is active. When set the value as 30V, the
controller does not detect under voltage
signal.
When engine speed has fallen below the set
1200
value for 10s, Under Speed is active. It will
initiate a shutdown alarm signal.
When engine speed has exceeded the set
value for 2s, Over Speed is active. It will
initiate a shutdown alarm signal.
When generator frequency has fallen below
the set value but Not equal to 0 for 10s,
45.0
Under Frequency is active. It will initiate a
shutdown alarm signal.
When generator frequency has exceeded
the set value for 2s, Over Frequency is
57.0
active. It will initiate a shutdown alarm
signal.
When the temperature value of the external
temperature sensor exceeds the set value,
"High
Temperature"
98
Detecting only after safety on delay has
expired.
temperature sensor).
When the external pressure sensor value
falls below this set value, "Low Oil Pressure"
timer is initiated. Detecting only after safety
on delay has expired. If the set value is 0,
103
low oil pressure signal will not be sent (this
only concerns pressure sensor and does
not concern low oil pressure warning signal
via configurable input port)
When the liquid level of the external sensor
falls below the set value and lasts more than
10
10s, "Low Fuel Level" signal is initiated. (it is
warning only)
5.0
If the set value is 0, only warning and not to
Version 1.2
2019-09-12
Description
timer
is
(this
only
concerns
Page 24 of 56
initiated.
external
Advertisement
Table of Contents
