Smartgen HGM8140D User Manual page 30

No. Item
09 Speed Drop Relay
10 Run Output
11 Fuel Pump Control
12 High Speed Control
13 Auto Mode
14 Trip and Stop
15 Audible Alarm
Heater Control
16
17 Fuel Output
18 Start Output
19 ECU Stop
20 ECU Power Supply
21 ECU Warning
22 ECU Shutdown
ECU Communication
23
Failure
24 Reserved
25 Reserved
26 Reserved
27 Reserved
28 Reserved
29 Reserved
Custom Period 1
30
Custom Period 2
31
Custom Period 3
32
HGM8140 Military Genset Controller
HGM8140 MILITARY GENSET CONTROLLER USER MANUAL
Close when the generator enters into Stop Idle delay/ Energized to
Stop delay (close time: Stop Idle delay).
Action when genset is normal running while deactivated when
engine speed is lower than the "crank disconnect speed".
Close when fuel level is lower than the "Fuel Pump On" value or
when low fuel level warning input is active; Open when fuel level is
higher than the "Fuel Pump Off" and low fuel level warning input is
deactivated;
Close when the generator enters into Warming Up delay while
open after cooling delay.
The controller is in automatic mode.
Output when shutdown alarms appeared.
When warning and shutdown alarms appear, audible alarm output
is fixed as 300s. When "alarm mute" or any keys on the panel
configurable input port is active, it can remove the alarm.
Controlled by the upper or lower limit of temperature sensor.
Activate when genset start, and break off when waiting for stop
steady.
Genset output only in crank output status.
Apply for engine with electronic injection ECU, which is used for
controlling ECU shutdown.
Apply for engine with electronic injection ECU, which is used for
controlling ECU power supply.
It is indicate that ECU has sent a warning alarm signal.
It is indicate that ECU has sent a shutdown alarm signal.
It is indicate that controller cannot communicate with ECU.
Detailed function description please to see the following content.
Version 1.2
Description
2019-09-12 Page 30 of 56