Smartgen HGM8140D User Manual page 18

No. Type
20 Over Power
21 Reverse Power
ECU Alarm
22
Shutdown
23 ECU Comm. Fail
Flexible Sensor 1
24
Open Circuit
Flexible Sensor 1
25
High
Flexible Sensor 1
26
Low
High Temp. Shut
27
Alarm Input
Low Oil Pressure
28
Shut Alarm Input
NOTE: ECU warns and shutdown alarms illustration, if there are detailed alarms display, controller will check engine
based on the content. Otherwise, please look up engine Manuel to get the information based on the SPN code.
HGM8140 Military Genset Controller
HGM8140 MILITARY GENSET CONTROLLER USER MANUAL
When controller detects the power value (power is positive) is higher
than the max. set value and the action select "shutdown", it will send
stop signals.
When controller detects the reverse power value (power is negative) is
higher than the max. set value and the action select "shutdown", it will
send stop signals.
After engine start, controller receives data signals, via J1939, controller
send stop signals.
After engine start, controller dose not receive data signals, via J1939,
controller send stop signals.
When the controller detects that the sensor is open circuit and the
action select "Shutdown Alarm", it will initiate a shutdown alarm and the
corresponding alarm information will be displayed on LCD.
When it is enabled, and controller detects the sensor value is higher
than the setting threshold value, controller will initiate shutdown alarm
signals.
When it is enabled, and controller detects the sensor value is lower
than the setting threshold value, controller will initiate shutdown alarm
signals.
When it is enabled, controller will initiate a shutdown alarm signals and
the corresponding alarm information will be displayed on LCD.
When it is enabled, controller will initiate a shutdown alarm signals and
the corresponding alarm information will be displayed on LCD.
Version 1.2
Description
2019-09-12 Page 18 of 56