Scops And Definitions Of Programmable Parameters; Contents And Scopes Of Parameters - Smartgen HGM8140D User Manual

7 SCOPS AND DEFINITIONS OF PROGRAMMABLE PARAMETERS

7.1 CONTENTS AND SCOPES OF PARAMETERS

No. Items
01 Start Delay
02 Stop Delay
03 Start
04 Pre-heat Delay
05 Cranking Time
06 Crank Rest Time
07 Safety On Delay
08 Start Idle Time
09 Warming Up Time
10 Cooling Time
11 Stop Idle Time
12 ETS Solenoid Hold
13 Fail to Stop Delay
14 Switch Close Time
15 Flywheel Teeth
Gen Abnormal
16
Delay
17 Gen Over
HGM8140 Military Genset Controller
HGM8140 MILITARY GENSET CONTROLLER USER MANUAL
Table 10 Parameters Settings and Scope
Parameters
(0~3600)s
(0~3600)s
(1-10) times
(0~3600)s
(3~60)s
(3~60)s
(1-60)s
(0~3600)s
(0~3600)s
(3~3600)s
(0~3600)s
(0~120)s
(0~120)s
(0-10.0)s
(10.0~300.0)
(0-20.0)s
Volt (30-620)V
Version 1.2
Defaults
Time from mains abnormal or remote start
1
signal is active to start genset.
Time from mains normal or remote start
1
signal is inactive to stop genset.
Max. start times if crank unsuccessfully.
When start times reach to the max. value,
3
fail to start signal will be initiated by
controller.
Time of pre-powering heat plug before
0
starter is powered up.
8 Time of starter power on
The waiting time before second power up
10
when engine start fail.
Alarms for
10 temperature, under speed, under frequency
/voltage, charge fail are inactive.
0 Idle running time of genset when starting.
Warming up time between genset switch on
10
and high speed running.
Radiating time before genset stop, after it
10
unloads.
0 Idle running time when genset stop.
Stop electromagnet‟s power on time when
20
genset is stopping.
Time between ending of genset idle delay
and stopped when "ETS time" is set as 0;
0 Time between ending of ETS hold delay and
stopped when "ETS Hold output time" is not
0.
Gen/Mains close pulse width, and 0s means
5.0
continuously output.
Tooth number of the engine, for judging of
starter separation conditions and inspecting
118.0
of engine speed. See the installation
instructions.
Alarm delay of generator over voltage and
10.0
under voltage.
264 When generator voltage has exceeded the
2019-09-12
Description
low oil pressure,
Page 23 of 56
high