Cummins Qsz13; Detroit Diesel Ddec Iii / Iv - Smartgen HGM8140D User Manual

13.7 CUMMINS QSZ13

Terminals of controller
Relay Output 1
Start relay output
Relay Output 2
Relay Output 3
CAN_SCR
CAN(H)
CAN(L)
Engine type: Common J1939

13.8 DETROIT DIESEL DDEC III / IV

Terminals of controller
Relay Output 1
Start relay output
CAN_SCR
CAN(H)
CAN(L)
Engine type: Common J1939
HGM8140 Military Genset Controller
HGM8140 MILITARY GENSET CONTROLLER USER MANUAL
Table 27 Engine OEM Connector
OEM connector of engine
45
-
16&41
19&41
-
1
21
Table 28 Engine CAN Connector
CAN port of engine
Expand 30A relay, battery
voltage of ECU is supplied
by relay.
-
-
CAN(H)
CAN(L)
Connect to starter coil directly
Setting to idle speed control, normally open output.
Making 16 connect to 41 during high-speed
running of controller via external expansion relay.
Setting to pulse raise speed control, normally open
output. Making 19 connect with 41 for 0.1s during
high-speed warming of controller via external
expansion relay.
CAN communication shielding line (connect with
controller‟s this terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Programmable relay output 1 set as "Fuel Output"
Connect to starter coil directly.
CAN communication shielding line.
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Version 1.2 2019-09-12
Remark
Remark
Page 49 of 56