Honda CBR650RA Shop Manual page 68

dummyhead dummyhead
FRAME/BODY PANELS/EXHAUST SYSTEM
INTAKE AIR DUCT (CBR650RA)
REMOVAL/INSTALLATION
Remove the middle cowl (page 2-7).
Release the harness clip [1] and front sub harness 12P
Left side:
(Black) [2] and 12P (Gray) [3] connectors from the
intake air duct [4].
Release the harness clip and front wheel speed sensor
Right side:
2P (Black) connector from the intake air duct.
Remove the two trim clips [5], socket bolt [6] and intake
air duct.
Installation is in the reverse order of removal.
UPPER INNER PANEL (CBR650RA)
REMOVAL/INSTALLATION
Remove the intake air duct (page 2-8).
Remove the trim clip [1].
Release the tab [2] from the slot [3] of headlight and
remove the upper inner panel.
Installation is in the reverse order of removal.
METER PANEL (CBR650RA)
REMOVAL/INSTALLATION
Remove the following:
– Windscreen (page 2-6)
– Middle cowls (page 2-7)
– Trim clip [1]
– Four socket bolts [2]
Disconnect
connector [3], then remove the meter panel [4].
Installation is in the reverse order of removal.
• Align the boss with the hole of the headlight stay.
2-8
the combination meter
Left side shown:
[4]
Left side shown:
[2]
[1]
Align
[2]
20P (Gray)
[3]
[2]
[3]
[1]
[6]
[5]
[3]
[4]
[1]