Honda CBR650RA Shop Manual page 336

dummyhead dummyhead
ENGINE REMOVAL/INSTALLATION
SERVICE INFORMATION
ENGINE REMOVAL/INSTALLATION
GENERAL
• A hoist or equivalent is required to support the motorcycle when removing and installing the engine.
• A floor jack or other adjustable support is required to support and maneuver the engine.
Do not use the oil filter as a jacking point.
• When removing/installing the engine, tape the frame around the engine beforehand for frame protection.
• When installing the engine, be sure to tighten the engine mounting fasteners to the specified torque in the specified sequence. If
you mistake the torque or sequence, loosen all mounting fasteners, then tighten them again to the specified torque in the correct
sequence.
• The following components can be serviced with the engine installed in the frame.
– Starter motor (page 6-5)
– Throttle body (page 7-13)
– Air cleaner housing (page 7-12)
– Water pump (page 8-10)
– Oil pump (page 9-4)
– Oil strainer (page 9-6)
– Camshaft (page 10-5)
– Cam chain tensioner lifter (page 10-20)
– Clutch (page 11-6)
– Gearshift linkage (page 11-19)
– Stator (page 12-4)
– Flywheel (page 12-5)
– Starter clutch (page 11-14)
– Cylinder head/valves (page 10-11)
• The following components require engine removal for service.
– Transmission (page 13-7)
– Crankshaft (page 14-4)
– Piston/cylinder (page 14-13)
15-2