Honda CBR650RA Shop Manual page 288

dummyhead dummyhead
CLUTCH/GEARSHIFT LINKAGE/STARTER CLUTCH
Inspect the following parts for scratch, damage,
abnormal wear and deformation.
– Clutch lifter bearing
– Clutch lifter pin
– Clutch springs
– Spring seats
– Judder spring
– Clutch discs/plates
– needle bearing
– Clutch outer guide
– Oil pump drive/driven sprocket
– Oil pump drive chain
– Mainshaft
Measure each part according to CLUTCH/GEARSHIFT
LINKAGE/STARTER CLUTCH SPECIFICATIONS
(page 1-8).
Replace any if it is out of service limit.
• Replace the clutch springs as a set.
• Replace the clutch discs and plates as a set.
INSTALLATION
Apply molybdenum oil solution to the clutch outer guide
[1] sliding surface and install it to the mainshaft.
Apply oil to the oil pump drive sprocket [1] and driven
sprocket [2] teeth.
Apply molybdenum oil solution to the oil pump drive
sprocket sliding surface.
Install the oil pump drive/driven sprocket and drive
Install the oil pump
chain [4] as an assembly.
driven sprocket with
its "OUT" mark [3]
Apply a locking agent to the oil pump driven sprocket
facing out.
washer-bolt [5] threads (page 1-17).
Temporarily install the oil pump driven sprocket washer-
Be careful not to
bolt.
drop the parts into
the oil pan.
11-10
[1]
[1]
[3]
[2]
[5]
[4]