Honda CBR650RA Shop Manual page 298

dummyhead dummyhead
CLUTCH/GEARSHIFT LINKAGE/STARTER CLUTCH
INSPECTION
Inspect the following parts for scratch, damage,
abnormal wear and deformation.
– Shift drum stopper plate
– Shift drum stopper arm
– Shift drum stopper arm return spring
Replace if necessary.
Check the gearshift spindle [1] for wear, damage or
bending.
Check the return spring [2] for fatigue or damage.
GEARSHIFT SPINDLE NEEDLE
BEARING REPLACEMENT
Remove the gearshift spindle (page 11-19).
Remove the bolt [1], gearshift spindle oil seal setting
plate [2], oil seal [3] and needle bearing [4].
Apply engine oil to a new gearshift spindle needle
bearing, then install it into the crankcase.
Apply grease to a new oil seal lips, then install it into the
crankcase until it is flush with the crankcase surface.
Apply locking agent to the gearshift spindle oil seal
setting plate bolt threads (page 1-17).
Install the gearshift spindle oil seal setting plate
between the crankcase tabs [5], then tighten the bolt.
INSTALLATION
Apply a locking agent to the stopper arm pivot bolt [1]
threads (page 1-17).
Install the following:
– Return spring [2]
– Washer [3]
– Stopper arm [4]
– Pivot bolt
• Align the stopper arm groove with the spring end.
Tighten the stopper arm pivot bolt to the specified
torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
11-20
[2]
[1]
[4]
[3]
[1]
[2]
[2]
[3]
[5]
Align
[4]
[1]