Honda CBR650RA Shop Manual page 211

dummyhead dummyhead
ARMATURE
Clean the metallic debris off the commutator bars [1].
Do not use emery
or sand paper on
Check the commutator bars for discoloration.
the commutator.
Check for continuity on the armature as follows:
– Between pair of commutator bars; there should be
continuity.
– Between each commutator bar and the armature
shaft [2]; there should be no continuity.
STARTER RELAY SWITCH
OPERATION INSPECTION
Remove the main seat (page 2-11).
Shift the transmission into neutral or squeeze the clutch
lever with the sidestand retracted.
Turn the ignition switch ON with the engine stop switch
turned " ". Push the starter switch.
The coil is normal if the starter relay switch [1] clicks.
If you don't hear the starter relay switch "CLICK",
inspect the relay coil circuits.
RELAY COIL CIRCUIT INSPECTION
Remove the right rear cowl (page 2-12).
POWER INPUT LINE
Release the connector boot from the starter relay
switch 2P (Black) connector [1].
Turn the ignition switch ON with the engine stop switch
turned " ".
Measure the voltage between the 2P (Black) connector
terminal and ground.
CONNECTION: Yellow/red (+) – Ground (–)
There should be battery voltage when the starter switch
is pushed.
ELECTRIC STARTER
[1]
[2]
[1]
[1]
Y/R
6-7