Honda CBR650RA Shop Manual page 482

dummyhead dummyhead
IMMOBILIZER SYSTEM (HISS)
18.Turn the ignition switch ON (with the first new key registered in step 13). The HISS indicator comes on and it remains on.
• The code of the first new key is recognized by the ECM.
• If there is any problem in the immobilizer system (HISS), the system will enter the diagnostic mode and the indicator will remain
on for approx. ten seconds, then it will indicate the diagnostic code (page 22-12).
19.Wait two seconds or more, then completely close the throttle grip.
20.Wait two seconds or more, then open the throttle grip fully and hold.
21.Wait two seconds or more, then the indicator remains on for approx. two seconds, then it blinks four times repeatedly.
• The immobilizer system (HISS) enters the registration mode. Registration of the original key used in step 5 is cancelled.
• Complete the procedure 18 through 20 within 25 seconds. If 25 seconds or more have passed, restart from the step 17.
22.Turn the ignition switch OFF and remove the key. Completely close the throttle grip.
23.Open the throttle grip 5 ° to 60 ° and hold.
24.Turn the ignition switch ON with a second new key (Never use the key registered in previous step). The indicator comes on for
two seconds then it blinks four times repeatedly.
• The second new key is registered in the ECM.
• If there is any problem in the registration, the system will enter the diagnostic mode and the indicator will remain for approx. ten
seconds, then it will indicate the diagnostic code (page 22-12).
• Keep the other transponder key away from the immobilizer receiver more than 50 mm (2.0 in).
25.Repeat the steps 22 and 24 when you continuously register the other new key.
The ECM can store up to four key codes (The four keys can be registered).
26.Turn the ignition switch OFF, then completely close the throttle grip. Disconnect the SCS short connector.
27.Turn the ignition switch ON with the registered key.
• The immobilizer system (HISS) returns to the normal mode.
28.Check that the engine can be started using all registered keys.
When all keys have been lost:
1. Obtain a new ECM and new key set.
2. Replace the ignition switch with a new one (page 21-14).
3. Replace the ECM with a new one (page 4-76).
4. Turn the engine stop switch " " and the ignition switch ON with a first new key. The HISS indicator comes on for two seconds,
then it blinks four times repeatedly.
• The first new key is registered in the ECM.
• If there is any problem in the registration, the system will enter the diagnostic mode and the indicator will remain for approx. ten
seconds, then it will indicate the diagnostic code (page 22-12).
5. Turn the ignition switch OFF and remove the first new key.
6. Turn the ignition switch ON with a second new key. The HISS indicator comes on for two seconds, then it blinks four times
repeatedly.
• The second new key is registered in the ECM.
• If there is any problem in the registration, the system will enter the diagnostic mode and the indicator will remain for approx. ten
seconds, then it will indicate the diagnostic code (page 22-12).
7. Turn the ignition switch OFF and remove the second new key.
• The system will not enter the normal mode unless the two keys are registered in ECM.
• The third new key cannot be continuously registered. When it is necessary to register the third key, follow the procedures "When
the key has been lost, or additional key is required" (page 22-4).
8. Check that the engine can be started using all registered keys.
9. Replace the remaining key set parts.
22-6