Honda CBR650RA Shop Manual page 235

dummyhead dummyhead
PAIR CONTROL SOLENOID VALVE
INSPECTION
Remove the PAIR control solenoid valve (page 7-20).
Check that air flows (A) to (B) when the 12 V battery is
connected to the PAIR control solenoid valve terminals.
Air should not flow (A) to (B) when the battery is
disconnected.
Measure the resistance between the 2P connector [1]
terminals of the PAIR control solenoid valve.
STANDARD: 23 – 27 Ω (20°C/68°F)
If the resistance is out of the specification, replace the
PAIR control solenoid valve.
PAIR CHECK VALVE REMOVAL/
INSTALLATION
Pull off the heat guard rubber [1] from the check valve
cover joint [2].
Remove the two bolts [3] and check valve cover [4].
Remove the PAIR check valves [1] and baffle plates [2].
Installation is in the reverse order of removal.
• Apply locking agent to the threads of the PAIR check
valve cover bolt (page 1-17).
TORQUE:
PAIR check valve cover bolt:
12 N·m (1.2 kgf·m, 9 lbf·ft)
FUEL SYSTEM
(B)
[2]
[1]
[4]
[2]
[1]
(B)
(A)
[1]
[3]
7-21