Honda CBR650RA Shop Manual page 257

dummyhead dummyhead
Remove the oil strainer [1] and seal ring [2].
Clean the oil strainer screen [3] and check for damage.
INSTALLATION
Clean any gasket material from the mating surfaces of
Be careful not to
the oil pan.
damage the mating
surfaces.
Apply engine oil to a new seal ring [1] and install it onto
the oil strainer [2].
Install the oil strainer into the crankcase while aligning
the oil strainer boss with the crankcase groove.
Clean the oil pan mating surface thoroughly.
Apply liquid sealant (TB1207B manufactured by Three
Bond or equivalent) to the oil pan mating surface as
shown.
• Do not apply more liquid sealant than necessary.
Install the oil pan [1] and bolts [2] to the crankcase.
Tighten the bolts in a crisscross pattern in 2 or 3 steps.
Install the exhaust pipe/muffler (page 2-17).
Fill the engine with the recommended engine oil and
check that there are no oil leaks (page 3-10).
LUBRICATION SYSTEM
[2]
[3]
[1]
Align
[2]
[1]
[1]
[2]
9-7