Honda CBR650RA Shop Manual page 468

dummyhead dummyhead
LIGHTS/METERS/SWITCHES
CLUTCH SWITCH
Disconnect the clutch switch connectors [1] and check
for continuity between the switch terminals.
There should be continuity with the clutch lever
squeezed, and no continuity when the clutch lever is
released.
SIDESTAND SWITCH
INSPECTION
Remove the throttle body (page 7-13).
Disconnect the sidestand switch 2P (Black) connector
[1].
Check for continuity between the switch side connector
terminals.
There should be continuity with the sidestand retracted,
and, no continuity when the sidestand is lowered.
REMOVAL/INSTALLATION
Remove the throttle body (page 7-13).
Disconnect the sidestand switch 2P (Black) connector
[1] and remove the sidestand switch wire [2] out of the
frame.
Remove the bolt [1] and sidestand switch [2].
Installation is in the reverse order of removal.
• Align the switch pin with the hole in the sidestand
and the switch groove with the return spring pin.
• Replace the switch bolt with a new one.
TORQUE:
Sidestand switch mounting bolt:
10 N·m (1.0 kgf·m, 7 lbf·ft)
21-18
CBR650RA shown:
[1]
[1]
Align
[2]
[1]
[1]
Align