Honda CBR650RA Shop Manual page 442

dummyhead dummyhead
ANTI-LOCK BRAKE SYSTEM (ABS)
ABS MODULATOR
REMOVAL/INSTALLATION
Drain the brake fluid from the rear brake hydraulic systems (page 18-5).
Remove the following:
– Throttle body (page 7-13)
– ABS modulator cover (page 4-76)
Disconnect the ABS modulator 18P (Black) connector (page 19-9).
Pull the ECM [1] upward as shown.
Loosen the brake pipe joint nuts [2] to disconnect the brake pipes.
• When disconnecting, cover the end of the brake pipes to prevent contamination.
Remove the trim clips [3].
Release the boss [4] and slightly pull the ABS modulator tray [5] upward.
Remove the following:
– Two bolts [6] and washers [7]
– ABS modulator [8]
– Two collars [9]
Installation is in the reverse order of removal.
• Apply brake fluid to the threads of the brake pipe joint nuts.
TORQUE: Brake pipe joint nut: 14 N·m (1.4 kgf·m, 10 lbf·ft)
Fill and bleed the front and rear brake hydraulic systems (page 18-6).
[1]
[5]
[4]
19-26
[9]
[2]
[8]
[3]
[6]/[7]