dummyhead
dummyhead
ELECTRIC STARTER
GROUND LINE
Turn the ignition switch OFF.
Disconnect the starter relay switch 2P (Black)
connector [1].
Check for continuity between the 2P (Black) connector
terminal and ground.
CONNECTION: Green/red – Ground
There should be continuity when the transmission is in
neutral or when the clutch lever is squeezed with the
sidestand retracted (There is a slight resistance due to
the diode).
RELAY INSPECTION
Remove the starter relay switch (page 6-8).
Connect a 12 V battery to the starter relay switch as
shown.
There should be continuity between the cable terminals
when the battery is connected, and no continuity when
the battery is disconnected.
REMOVAL/INSTALLATION
Remove the right rear cowl (page 2-12).
Disconnect the negative (–) cable from the battery
(page 20-5).
Disconnect the starter relay switch 2P (Black)
connector [1].
6-8
[1]
G/R
(–)
(+)
[1]