Honda CBR650RA Shop Manual page 291

dummyhead dummyhead
Install the judder spring seat [1] and judder spring [2]
onto the clutch center [3] as shown.
Apply engine oil to the entire surface of clutch discs.
Install the clutch disc B [4] onto the clutch center.
Install the clutch plates A [5] (4 pcs) and discs A [6] (3
pcs) alternately, starting with the plate A.
Install the clutch disc C [7].
• Clutch disc B: lining color is black
• Clutch plate A: Small I.D.
Install the clutch lifter pin [1].
Install the spring seats [2] onto the clutch pressure plate
[3] grooves.
• Make sure that the spring seats are fully seated in
the pressure plate grooves.
Apply engine oil to the entire surface of clutch disc B.
Install the clutch disc B [4] onto the clutch pressure
plate.
Install the clutch plate B [5] by aligning its tabs with the
pressure plate grooves.
Put the clutch pressure plate assembly onto the clutch
center [6] by aligning each cam area and insert them by
rotating counterclockwise.
Install the clutch disc B tabs into the shallow slots of the
clutch outer [7].
CLUTCH/GEARSHIFT LINKAGE/STARTER CLUTCH
[5]
[3]
[6]
[1]
[3]
[7]
[6]
[4]
[2]
[1]
[7] [2]
[4]
[3]
[5]
[4]
[5]
11-13