Honda CBR650RA Shop Manual page 311

dummyhead dummyhead
ASSEMBLY
Clean the upper and lower crankcase mating surfaces
thoroughly, being careful not to damage them.
Check the crankcase oil passages for clogs, and clean
them if necessary.
Apply sealant (TB1207B manufactured by ThreeBond
or an equivalent) to the crankcase mating surface as
shown.
• Do not apply liquid sealant more than necessary.
• Do not apply liquid sealant to the crankcase main
journal bolts area and the oil passage area.
Clean the oil orifices in solvent thoroughly.
Check the oil orifices for clogs, and replace them if
necessary.
Install the oil orifices [1] by aligning its cut-out with the
groove of upper crankcase.
Install the dowel pins [1] into the upper crankcase.
CRANKCASE/TRANSMISSION
Align
[1]
[1]
13-5