Honda CBR650RA Shop Manual page 460

dummyhead dummyhead
LIGHTS/METERS/SWITCHES
DISASSEMBLY/ASSEMBLY
Remove the following:
– Six tapping screws [1]
– Upper case [2]
– Key tops [3]
– Tapping screw [4]
– Meter assembly [5]
– Lower case [6]
Assembly is in the reverse order of disassembly.
DIGITAL CLOCK SETTING
PROCEDURE
Turn the ignition switch ON.
1. Press and hold the SEL and SET buttons until the
The control is
hour digits starts flashing.
automatically
2. Press SEL button to select "12hr" or "24hr". Press
switched from the
SET button. The time format is set, and then the
setting mode to the
display moves to the clock adjustment.
ordinary display if
3. Press the SEL button until the desired hour is
the button is not
displayed (press and hold to advance the hour fast).
pressed for about
4. Press the SET button. The minute digits start
30 seconds.
flashing.
5. Press the SEL button until the desired minute is
displayed (press and hold to advance the minute
fast).
6. Press the SET button. The clock is set, and then the
display
adjustment ("ooooo" – "o" is indicated).
Turn the ignition switch OFF.
SPEEDOMETER
SYSTEM INSPECTION
If the speedometer does not operate, check the following:
• Combination meter initial operation (page 21-6)
• MIL blinking: If the MIL blinks, check the PGM-FI DTC
– ED, IIED, IIIED, IVED, FO, IIFO, KO, IIKO models (page 4-12)
– MA, IIMA, IN, TH, IITH, U, IIU, BR, IIBR models (page 4-46)
If the above items are OK, replace the combination meter (page 21-6).
21-10
moves to the backlight
[1]
[4]
"SEL"
Clock setting display flow:
brightness
1.
2.
3.
4.
5.
6.
[3]
[6]
[5]
"SET"
[2]