Honda CBR650RA Shop Manual page 183

dummyhead dummyhead
MAP SENSOR
REMOVAL/INSTALLATION
Lift the fuel tank and support it (page 3-4).
Disconnect the MAP sensor 3P (Black) connector [1].
Remove the screw [2] and MAP sensor [3].
Remove the O-ring [4] from the MAP sensor.
Installation is in the reverse order of removal.
• Replace the O-ring with a new one and coat it with
the engine oil.
TORQUE:
MAP sensor mounting screw:
3.4 N·m (0.3 kgf·m, 2.5 lbf·ft)
ECT SENSOR
REMOVAL/INSTALLATION
Drain the coolant (page 8-4).
Remove the cam chain tensioner lifter (page 10-20).
Disconnect the ECT sensor 2P (Blue) connector [1].
Remove the ECT sensor [2] and O-ring [3].
Installation is in the reverse order of removal.
• Replace the O-ring with a new one (do not apply oil).
TORQUE:
ECT sensor: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Fill and bleed the cooling system (page 8-4).
IAT SENSOR
REMOVAL/INSTALLATION
Lift the fuel tank and support it (page 3-4).
Disconnect the IAT sensor 2P (Black) connector [1].
Remove the screws [2] and IAT sensor [3].
Remove the O-ring [4] from the IAT sensor.
Installation is in the reverse order of removal.
• Replace the O-ring with a new one and coat it with
the engine oil.
TORQUE:
IAT sensor screw: 1.2 N·m (0.1 kgf·m, 0.9 lbf·ft)
PGM-FI SYSTEM
[2]
[3]
[1]
[1]
[2]
[3]
[4]
[2]
[4]
[3]
[1]
4-79