Honda CBR650RA Shop Manual page 412

dummyhead dummyhead
HYDRAULIC BRAKE
REAR MASTER CYLINDER
REMOVAL/INSTALLATION
Drain the brake fluid from the rear brake hydraulic
system (page 18-5).
Remove the stay bolt [1] and rear brake reservoir [2].
Disconnect the brake hose [1] by removing the oil bolt
When removing the
[2] and sealing washers [3].
oil bolt, cover the
end of the brake
Loosen the master cylinder mounting socket bolts [4].
hose to prevent
Support the right rider footpeg bracket [5] securely and
contamination.
remove the bracket socket bolts [6].
Remove the following.
– Cotter pin [1]
– Joint pin [2]
– Mounting socket bolts [3]
– Master cylinder [4]
Installation is in the reverse order of removal.
• Replace the sealing washers and cotter pin with new
ones.
• Be sure to rest the eyelet stopper pin against the
stopper when tightening the oil bolt.
TORQUE:
Rider footpeg bracket socket bolt:
27 N·m (2.8 kgf·m, 20 lbf·ft)
Rear master cylinder mounting socket bolt:
12 N·m (1.2 kgf·m, 9 lbf·ft)
Oil bolt:
34 N·m (3.5 kgf·m, 25 lbf·ft)
Fill and bleed the rear brake hydraulic system (page 18-6).
18-12
[2]
[2]
[3]
[4]
[5]
[3]
[1]
[1]
[6]
[4]
[1]
[2]