Honda CBR650RA Shop Manual page 399

dummyhead dummyhead
Install the snap ring [1] into the right pivot groove
securely.
• Do not reuse worm snap ring which could easily spin
in the groove.
• Make sure that the snap ring is firmly seated in the
groove.
LEFT SIDE
Press the needle bearing [1] out of the swingarm using
the special tools.
TOOLS:
[2] Remover attachment, 28 mm 07HMC-MR70100
[3] Pilot 17 mm
[4] Attachment, 22 x 24 mm
[5] Driver, 15 x 280L
Apply molybdenum disulfide grease to the rotating area
of a new needle bearing [1].
Carefully press the bearing in the left pivot with the
marked side facing up until the depth from the pivot end
surface is 4.5 – 5.0 mm (0.18 – 0.20 in), using the
special tools.
TOOLS:
[2] Driver
[3] Attachment, 37 mm
[4] Pilot, 28 mm
[5]
07746-0040400
[1]
07746-0010800
07949-3710001
[2]
07749-0010000
07ZMD-MBW0200
07746-0041100 or
07JAD-PH80400
REAR WHEEL/SUSPENSION
[1]
[2]
4.5 – 5.0 mm
(0.18 – 0.20 in)
[3]
[4]
[1]
[4]
[3]
17-13