Honda CBR650RA Shop Manual page 340

dummyhead dummyhead
ENGINE REMOVAL/INSTALLATION
Remove the drive sprocket bolt [1], washer [2] and drive
sprocket [3].
Support the motorcycle securely with a hoist or
equivalent.
Place a floor jack or other adjustable support under the
Do not use the oil
engine.
filter as a jacking
point.
• The jack height must be continually adjusted to
relieve stress for ease of bolt removal.
Disconnect the horn connectors [1] from the horn.
Remove the following:
– Front engine hanger bolts [2]
– Collar [3] (left side only)
Remove the following:
– Upper engine hanger bolts [1]
– Clips [2]
– Engine hanger bracket bolts [3]
– Both engine hangers [4]
Loosen the rear brake pipe stay bolt [1].
Remove the rear upper engine hanger nut [2], bolt [3]
and collar [4].
Remove the rear lower engine hanger nut [5] and bolt
[6].
Carefully lower the jack or adjustable support, then
During engine
remove the engine from the frame.
removal, hold the
engine securely and
be careful not to
damage the frame
and engine.
15-6
[1]
[2]
[3]
[1]
[3]
Left side shown:
[1]
[2]
[4]
[3]
[5]
[2]
[1]
[3]
[2]
[2]
[4]
[6]