Honda CBR650RA Shop Manual page 372

dummyhead dummyhead
FRONT WHEEL/SUSPENSION/STEERING
Pull the slide pipe assembly [1] out until you feel
resistance from the slider bushing. Then move it in and
out, tapping the bushing lightly until the outer tube [2]
separates from the slide pipe assembly.
The guide bushing will be forced out by the slider
bushing.
Carefully remove the slider bushing [1] by prying the
Do not damage the
slot with a screwdriver until the slider bushing can be
slider bushing,
pulled off by hand.
especially the
sliding surface. To
Remove the following:
prevent loss of
– Guide bushing [2]
tension, do not
– Back-up ring [3]
open the slider
– Oil seal [4]
bushing more than
– Stopper ring [5]
necessary.
– Dust seal [6]
INSPECTION
Inspect the following parts for damage, abnormal wear,
bend, deformation, scoring and teflon coating wear.
– Fork tube
– Fork slider
– Fork spring
– Rebound spring
– Spring collar
– Piston ring (Right side only)
– Fork rod
– Rod guide case (Right side only)
– Piston B ring (Right side only)
– Guide bushing
– Fork tube bushing
– Back-up ring
Measure each part according to FRONT WHEEL/
SUSPENSION/STEERING SPECIFICATIONS (page 1-
9).
Replace any part if it is out of service limit.
16-30
[1] [2]
[5]
[6]
[4]
[3]
[2]
[1]