Honda CBR650RA Shop Manual page 364

dummyhead dummyhead
FRONT WHEEL/SUSPENSION/STEERING
INSTALLATION (CBR650RA)
When the fork is disassembled:
Insert the fork leg [1] into the bottom bridge, handlebar,
top bridge and temporarily tighten the pinch bolt [2].
Tighten the fork cap to the specified torque using the
special tools.
TOOL:
[3] Fork cap wrench
TORQUE: 35 N·m (3.6 kgf·m, 26 lbf·ft)
Install the fork leg into the bottom bridge, handlebar and
Route the wires,
top bridge. Be sure to align the handlebar stopper pin
cables and hose
[1] with the hole [2] in the top bridge.
properly (page 1-
22).
Align the top end of the fork pipe [3] with the upper
surface of the top bridge as shown.
Tighten the bottom bridge pinch bolts [4] to the
specified torque.
TORQUE: 42 N·m (4.3 kgf·m, 31 lbf·ft)
Tighten the top bridge pinch bolt [1] to the specified
torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Tighten the handlebar pinch bolts [2] to the specified
torque.
TORQUE: 27 N·m (2.8 kgf·m, 20 lbf·ft)
16-22
070MA-MGP0100
[1]
[2]
Align
[2]
[1]
[3]
Front
[3]
[4]
[1]
[2]