Honda CBR650RA Shop Manual page 357

dummyhead dummyhead
HANDLEBAR GRIP REPLACEMENT
Remove the handlebar weight (page 16-13).
Remove the handlebar grip [1].
Clean the inside surface of the handlebar grip and
outside surface of the handlebar and throttle pipe.
Apply Honda bond A or equivalent to the inside surface
of the grips and to the clean surface of the left
handlebar and throttle pipe.
Wait 3 – 5 minutes and install the grip.
Allow the adhesive
Rotate the grips for even application of the adhesive.
to dry for 1 hour
before using.
Install the handlebar weight (page 16-13).
FRONT WHEEL
REMOVAL
Remove the bolts [1] and brake calipers [2].
Support the brake caliper with a piece of wire so that it
Do not operate the
does not hang from the brake hose. Do not twist the
brake lever after the
brake hose.
brake caliper is
removed.
Loosen the left axle holder bolts [1].
Remove the axle bolt [2].
Support the motorcycle securely and raise the front
wheel off the ground using a safety stand or a hoist.
Loosen the right axle holder bolts [1].
Remove the axle [2] and front wheel.
Be careful not to
damage the pulser
ring.
FRONT WHEEL/SUSPENSION/STEERING
[1]
ED model shown:
[1]
[1]
[2]
[1]
[2]
[2]
[1]
16-15