Table of Contents
Advertisement
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0334
User Action:
Information only; no action is required.
• FQXSPIO2000J: The connector [PhysicalConnectorElementName] has been disconnected.
This message is for the use case when an implementation has detected a Connector was Disconnected.
Severity: Warning
Serviceable: Yes
Automatically notify Support: No
Alert Category: Warning - Other
SNMP Trap ID: 60
CIM Prefix: PLAT CIM ID: 0265
User Action:
Complete the following steps until the problem is solved:
1. Re-install COM Port Card/VGA connector and cable.
2. Check Lenovo Support for known service bulletins and Tech tips.
3. If problem persists, collect Service Data log.
4. Contact Lenovo Support.
• FQXSPIO2002I: The System [ComputerSystemElementName] has detected a POST Error
deassertion.
This message is for the use case when an implementation has detected that Post Error has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0185
User Action:
Information only; no action is required.
• FQXSPIO2003I: System [ComputerSystemElementName] has recovered from a diagnostic
interrupt.
This message is for the use case when an implementation has detected a recovery from a Front Panel NMI
/ Diagnostic Interrupt
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0223
User Action:
Information only; no action is required.
• FQXSPIO2004I: Bus [SensorElementName] has recovered from a bus timeout.
.
Chapter 2
XClarity Controller events
59
Advertisement
Table of Contents
