Lenovo 7D9F Manual page 187

1. Original UEFI settings are still present. If customer desires to continue using the original settings,
select Save Settings.
2. If User did not intentionally trigger the reboots, check logs for probable cause. For example, if there
is a battery fault event, follow the steps to resolve that event.
3. Undo recent system changes (settings or devices added). Verify that the system boots. Then, re-
install options one at a time to locate the problem.
4. Check Lenovo Support site for an applicable service bulletin or firmware update that applies to this
error. Update UEFI firmware if applicable.
5. Save customer's UEFI configurations, then remove and re-install CMOS battery for 30 seconds to
clear CMOS contents. If it boots successfully, then restore system settings.
6. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0034L: The TPM could not be initialized properly.
Severity: Error
User Action:
Complete the following steps:
1. Reboot the system. Reflash UEFI image.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0038I: A correctable error (Type [arg1]) has been detected by processor [arg2].
Severity: Info
User Action:
Complete the following steps:
1. A correctable error detected by CPU. No action is needed.
2. Below list provides the description for error type:
a. "1" indicate PIE(Power Management, Interrupts, Etc.) error.
b. "2" indicate NBIO(Northbridge IO) error.
c. "3" indicate SMU(System Management Unit) error.
d. "4" indicate PSP(Platform Security Processor) error.
e. "5" indicate MP5(Microprocessor5 Management Controller) error.
• FQXSFPU0063N: CPU [arg1] cores [arg2] disabled.
Severity: Error
User Action:
Complete the following steps:
1. Update UEFI firmware to the latest version.
2. Power off the system and remove the A/C power.
3. Restore the A/C power and power on the system.
4. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU4033F: TPM Firmware recovery is in progress. Please DO NOT power off or reset system.
Severity: Warning
User Action:
Information only; no action is required.
. 183
Chapter 3 UEFI events